User's Manual

ULP EMS Operator Guide Maintaining and Operating the ULP Network
On-Ramp Wireless Confidential and Proprietary 30 010-0045-00
5. Physical device installation is completed. The devices will connect at this time, and they are
visible in the EMS system.
6. Post installation delivers the completed work order that validates the Node ID (MAC
address), application, and installation location to the CIMA operator for post installation
application data configuration.
3.5.6 Adding an End Device
To add a device, complete the following steps:
1. The operator must have the work order that maps the radio Node ID (MAC address) to the
device type and physical location.
2. Log in to the EMS with an admin or operator account.
3. Make sure a Gateway is established.
4. Make sure an AP is up and running.
NOTE:
Make sure the AP is providing wireless coverage to the physical location of the
device to install.
5. Click the Devices tab.
6. In the Devices pane, click Node.
NOTE:
If this is the first time adding an end device, this page will be blank.