User's Manual

ULP EMS Operator Guide Maintaining and Operating the ULP Network
On-Ramp Wireless Confidential and Proprietary 34 010-0045-00
Table 3. RMU UI and LI Values
Interval (UI and LI)
Value
UI
60 per day (24 minutes)
LI
Every update interval
4. After entering the UI and LI for a device, click Save, and click Yes. The device that was just
added displays on the list as Not Joined with an asterisk in the Pending Value field. This
denotes that the device has been configured in the EMS, but it has not yet joined the
network. The device will stay in this state until it is physically deployed, powered on, and
joins the network.
NOTE:
Sysmon nodes show a critical alarm after they have been added to the EMS, prior to
being powered on. Ignore this alarm. After the Sysmon nodes are powered on, this
alarm will be automatically cleared.
5. Optional: To confirm that the correct UI/LI for the device was set, select the device from the
list of devices, and click the UI/LI Config tab. Verify the configuration information.
After verifying the configuration information, the node has been added to the EMS. The
work order proceeds with the physical installation of the device. After the devices are
powered on in the field, the EMS operator can confirm (in the EMS) that these devices have
joined the network. The operator can easily identify which device has joined the network, as
the Pending Value asterisk is not displayed.