User's Manual

ULP EMS Operator Guide Maintaining and Operating the ULP Network
On-Ramp Wireless Confidential and Proprietary 43 010-0045-00
as an AP cannot operate without a GPS fix. The operator may need to roll a service truck to
establish whether there is any issue with the antenna connectivity of the GPS antenna to the AP.
3.6.1.17 AP VC-TCXO High Temperature
This alarm is the result of the AP operating in a temperature extreme that is above its intended
design target. The operator should investigate the AP's physical location, and validate that it is
operating within its installed operating parameters. If the physical operating environment for
the AP is within its operating parameters, the operator should call On-Ramp Wireless.
3.6.1.18 AP PA High Temperature
This alarm is the result of the AP operating in a temperature extreme that is above its intended
design target. The operator should investigate the AP's physical location, and validate that it is
operating within its installed operating parameters. If the physical operating environment for
the AP is within its operating parameters, the operator should call On-Ramp Wireless.
3.6.1.19 AP Max VGA Exceeded
This alarm is not likely to be cleared without a service call to On-Ramp Wireless. If this alarm is
detected, call On-Ramp Wireless.
3.6.1.20 AP Min VGA Exceeded
This alarm is not likely to be cleared without a service call to On-Ramp Wireless. If this alarm is
detected, call On-Ramp Wireless.
3.6.1.21 AP Fragmented Channel Threshold Exceeded
This alarm is not likely to be cleared without a service call to On-Ramp Wireless. If this alarm is
detected, call On-Ramp Wireless.
3.6.1.22 Message Processing Delay
If this alarm occurs, the time difference between the last queued database raw message and the
last inserted database message has grown longer than the default (default is 5 minutes). This
means that database actions are falling behind and may require a DBA to take database action.
For example, the DBA may need to perform database related actions, such as purging or
partitioning. Call On-Ramp Wireless for help in analyzing this type of alarm.
3.6.2 Configuring Alarm Emails
Configure the EMS alarm notification system before using it.
To configure the EMS notification alarm system, log in as a user with admin privileges.
NOTE:
The EMS email configuration in the /opt/onramp_apps/nms_config.properties file must
be configured according to the directions in the EMS Installation Guide.