Engineering Data Sheet (1)

ENGINEERING DATA SHEET
2475
Ref: 9820.00
Page: 1 of 2
Date: 23 Jan.2009
Cancels: All Previous
Point of Manufacture - Campbellsville
Bare Details:
Specifications:
Bore: 4" & 2.5"
Stroke: 2.75"
Maximum pressure : 250(17.24) psig(bar)
Sheave OD: 13.75"
Sheave PD: 13.5"
Inlet size: 1" NPT
Discharge size: 0.5" NPT
Belt Type / Quantity: A/1
Min/Max RPM: 575/1600
Lubrication:
Type: XL300*, All-Season T30 Select**, XL740Ht***
Sump capacity: 1.30(1.23) qt(l)
* Adjust viscosity to suit ambient conditions, XL300 should not be used in ambients below 40
0
F.
Use premium quality, non-detergent, single-viscosity petroleum oils with R & O additives.
** Required for duty cycles above 70% load. Check lubricant compatibility sheet before using.
*** Required for ambients in excess of 100
0
F. Check lubricant compatibility sheet before using.
Tank Details:
Tank size / Configuration: 80 Gal/Vertical; 80 Gal/Horizontal
Pressure rating: 200(13.8) psig(bar)
Codes: ASME Sec VIII & CRN
Motor Details:
AMP draw:
200-3-60 200-1-60 230-1-60 230-3-60 460-3-60 575-3-60
5HP 17.5 32.2 28 15.2 7.6 6.1
7.5HP 25.3 40 22.0 11 9.0
Note: Nominal Amps are based on NEC full load amperage rating for this size motor.
Actual nameplate amps may vary according to motor design and/or motor manufacturer.
5 HP 7.5 HP
Efficiency * *
Motor RPM 1775/3450 3450
* Motors comply with EPACT standards.