Form P6513 CCN 03530515 Edition 9 December 2006 Starter Relay Valve SRV Series User Manual Save These Instructions
Product Description This product is a non-regulating, pneumatically-operated, relay valve designed to provide control over fluid flow to the starter motor in an air starter-based, internal combustion engine starting system. WARNING General Product Safety Information • • • • Read and understand this manual before operating this product. It is your responsibility to make this safety information available to others that will operate this product.
Product Parts Information CAUTION The use of other than genuine Ingersoll Rand replacement parts may result in safety hazards, decreased Starter Relay Valve performance, and increased maintenance, and may invalidate all warranties. Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll Rand Authorized Service Center.
Starter Relay Valve Exploded View 1 2 3 4 5 6 7 8 9 10 11 12 13 (Dwg.
Starter Relay Valve Parts List Part Number Item 1 Part Description Aluminum Models Valve Housing SRV150SS (Stainless Steel) SRV150T-LT (Low Temperature Aluminum) SRV150SST-LT (Low Temperature Stainless Steel) SRV150SS-40 45504404 45504362 for SRV100 SRV100-40 - - - for SRV125 SRV125-40 - - - for SRV125F SRV125F-40 - - - for SRV125T 04333639 - - - for SRV150 SRV150-40 - - - for SRV150T SRV150T-40 - - - HSPPS-2 HSPPS-2 HSPPS-2 HSPPS-2 * SRV150-210 * SRV150-210 ** 45504
Optional Equipment for SRV125F M L U U J A K B P Q C G Q N R P O F T H S I E D (Dwg.
Installation of the Tune-up Kit Disassembly of the Starter Relay Valve 1. Bleed off the pressure. 2. Clamp the Relay Valve in a vise with the Retaining Ring (12) up. 3. Carefully remove the Retaining Ring. The End Plug (10) should spring out. If it does not, tap the Valve Housing (1) lightly with a soft hammer until the End Plug springs out. 4. Remove the End Plug, Spring (8), and Piston Assembly (4). 5. Remove and discard all used O-rings and Bumper (5). 6.
www.irtools.
