ED 11/00B/2017 15:47:32 om 80448517 Revision C September 2017 Contact-Cooled Rotary Screw Air Compressor Product Maintenance Information ® Save These Instructions an Innersole Rand.
RELEASED 11/00/2017 15:47:32 ome ® AIR COMPRESSOR MAINTENANCE WB Maintenance Prompts WB Maintenance Chart THe Semite PRIG Si BASHING LET WII Pharaohs SEERS dependent Repatriation Should Be perforation per the Indemnification: Bat i the on the service level selected. Refer to the Product Information manual for following priority: {1} Perform maintenance when indicated by the controller; information about service level settings.
HEADCASE 11/008/2017 1 ® TAY 32 GE BW Routine Maintenance. This Set refers £5 the Various pennants WHICH vague periodic maintenance amid replacement. Re far to safety information and maintenance procedures prior to carrying out any of the maintenance in the following sections. # Checking Coolant Level A Gore ct at operating temperature B.
EASED 11/00t/201 ® ® Sampling Coolant Bring the compressor up to operating temperature: :: Stop the compressor, :: Isolate the compressor from the external ai system. Bow ow Press Hh BRETON SEG 16 Va the Separatist tank and effendi. Fixed speed compressors can take more than two minutes to fully DE-prassurize once stopped. 5: Die 3 Sail i th sie fll 567 DO NOY i a Sample fro the drain part or coolant fair port. Use new hose on the pump far each sample: Failure to do this can give false reads. See Figure 3.
® EASED 11/00t/201 ® Cleaning / Checking Lowdown Orifice ‘The lowdown stern is used to pneumatically control package loading.
EASED 11/00t/201 7: Remove top assembly by removing cit bolts while supporting assembly properly: 8 DISCOTHEQUE iotas fbi chore 9. Disconnected grounding cable from cooler. 10. Cara Reich coastal Cooler acidic: To install 12: SHO this Compressor 2: isolate the compressor from the system. 3 Pr SE Wha SHHTGRIEY SED 1 Va He IHG SHERATAN HAI Bhd Gird Fired speed compressors can take more than two minutes to fully DE-pressurize once stopped Ensure that the rain power disconnect switch i locked off and tagged.
RELEASED 11/00b/2017 147:32 ome ® # Changing Pulleys / Belts 5. Remove the outer belt guard from the aired support by removing the nut and washer from the threaded stud, two bolts and washers firm the aired support and remove the clips between the guards. Check belt tension regularly, especially if looseness is suspected. A belt tension measurement device can be used to determine the tension of the. bile: The Gilt ERG RE Fe Menotti aie pH many bani he Hist Hod .
EASED 11/00t/201 ® B Pressure Relief Valves AGS PHASE Ali (OAH HIS ard ai Ear Kak) Sosa i CHECKS Mega fo tract Ingratiating Tc test bi atheist preassigned Hallucinate manually to verify that the mechanism is functioning correctly and that a small amount of air is released.
EASED 11/00t/201 Table 4: General Faults (cont.) SYMPTOM CAUSE REMEDY. Panes or doors are not closed properly: Rectify fault Air leaks from internal pipework / components. Replace seals torque properly or replace part. Fan or fan motor bearings worn: Hera or replace. L38 delis impacting oi fair dung titian. iis di eck philandering. Compressor package Produces Riboflavin valve stick aspen Respire br replace. Pressure relief valve not seating correctly. Beauvoir or replace.
EASED 11/00t/201 ‘Table 5: Controller Faults {indicated on the controvert] (cont) Xe-50 DISPLAY | MEANING CAUSE REMEDY. Check and modify settings. Review system Compression operating above rated requirements and contact your local innersole Rand pressure, : representative, Low coolant level, Check Toi Teas. "S66 also f discharge aif is a : contaminated with coolant. Top off coolant.
RELEASED 11/00/2017 15:47:32 ome R-11 INTEGRATED DRYER MAINTENANCE HB Maintenance Chart ® Troubleshooting Fisk optima perforation fm inl eve fallow thi pe Heidi maintenance schedule described below. Review the information Manual for details on dryer operation.
EASED 11/00t/201 ‘Table 8: General Faults {Dryer} TROUBLE _| DISPLAY POSSIBLE CAUSE REMEDY No powering the line: Restore thi power the fine posh La [rT —— Check cabling; f the ruble persists, replace it Problems with the electronic control board. | Check ie electronic controllers; if the trouble persists, replace it Thea Check the remote ON/OFF contact. r= Dryer in stand-by. Wat 2 Es REE Compressed air. electrocution inverted. Check if the compressed air inlét/outlet is connected properly.
RELEASED 11/00b/2017 1514732 om ® TROUBLE: | DISPLAY: POSSIBLE CAUSE REMEDY E © a Check the probe; if the trouble persists: replace it Check the electronic control board; if the trouble persists, replace it. ECD |wetomonmienmpomor Contact our Service Center to check the gas charge: Check if the compressed air inlet/outlet is connected properly. a a Check if the connecting tubing is clogged; in case proceed accordingly. Check if any valves are closed. Z Check the condition of any filter.
® EASED 11/00t/201 # Deconstructionist the Integrated Dryer Recommission the dryer and the relevant packaging in compliance with the lines locally in force. Pay particular attention to the refrigerant, as it curtains part of the. refrigerating compressor lubricating ofl. Always contact ax waste disposal and recycling utility: Table 9: Recycling Disassembly ® Filter Element Replacement 1.
