Installation guide

ManualsBrandsInglis ManualsWasherOfficial Inglis washer

Part No. 3361044

IMPORTANT:

Read and save

these instructions.

IMPORTANT:

Installer: Leave Installation Instructions with

the homeowner.

Homeowner: Keep Installation Instructions

for future reference.

Save installation Instructionsfor local

electrical inspector's use.

Washer

Summary of content (5 pages)

PAGE 1
Part No. 3361044 IMPORTANT: Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save installation Instructionsfor local electrical inspector's use.
PAGE 2
Hot and cold water faucets: Must be within 1.2 meters (4') of the back of the washer and provide water pressure 34 to 690 KPa (5-100 PSI). Untape and open washer lid. Remove all material from washer. Beforeyou start... Check location where washer will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation. Laundry tub drain system: Needs a 75 liter (16.5 Imperial gallon) laundry tub.
PAGE 3
Now start... IMPORTANT'. THIS PROCEDURE MUST BE FOLLOWED TO ASSURE PROPER INSTALLATION. Use new hoses and washers that came with your washer. With washer in laundry area. Coupling Washer Clamp Insert a flat washer into each end of the inlet hoses. Check that washers are firmly seated in couplings. Ribbed Stop Inlets are plastic. Do Not strip or crossthread, 0-0.64 cm (0-1/4") Read, then remove label that covers • yellow shipping strap and power supply cord.
PAGE 4
Open clamp and slide over "hook" end of drain hose to secure the rigid and corrugated sections together. • / Insert legs into correct holes at each front corner of washer until nuts touch washer, Do not tighten nuls until Step 15, I! drain hose cannot be strapped in place, it must be of exact length so the "hook" end is held tightly over the edge of the tub or standpipe. See Figure D. Floor Damage Slide washer onto cardboard or hardboard before moving across floor.
PAGE 5
Closet door Closet door Recessedarea instructions. 7.5 cm (3") This washer may be installed in a recessed area or closet. The installation spacing is the minimum allowable. Additional spacing should be considered for ease of installationand servicing. If closet door is installed, the minimum air openings in top and bottom are required. Louvered doors with air openings in top and bottom are acceptable. Companion appliance spacing should be considered. 310 sq. cm (_ O0 43 cm (17") © f,_ 7.