User's Manual PCI ULTRA SCSI HIGH-PERFORMANCE BUS MASTER HOST ADAPTER INI-9100U, INI-9100UW

10-3
Updating interrupts and hardware settings
The following interrupt configuration settings are suggested as the most
effective means of providing a controller interrupt to the host adapter:
• Host Adapter interrupt levels available are 9,11, 15, (IRQ 11 is
recommended)
• Avoid using interrupt 10 as the controller interrupt.
• Set first SCSI disk ID to 0 (first time install requirement)
• Set tape target ID to 2. (If tape is in use)
• Set CD-ROM target ID to 5. (If CD-ROM is in use)
Please Refer to your system documentation to set the interrupt levels and your
peripheral documentation for help in setting SCSI IDs.
Installing the Initio driver in a new SCO UNIX system
1. Insert the SCO UNIX N1 boot disk into the floppy drive and turn on
the system. A screen similar to the following will be displayed (see
figure 10-1):
figure 10-1 SCO UNIX system boot screen
2. Type: link < ENTER >. The system will respond by displaying the
following screen (see figure 10-2):