User's Manual

Promi-ESD User Manual – Appendix.E Regulatory Information E-4

EU Compliance

 Regulatory compliance of the Promi-ESD

The Promi-ESD are made for OEM integrations only. The European regulations

applying to the Promi-ESD is the R&TTE Directive 1999/5/EC.

Promi-ESD meets the following requirements of the R&TTE Directive.

R&TTE

Directive article

Test category Harmonized standard

Article 3.1(a) Protection of health and safety EN 60950, EN 50385

Article 3.1(b) EMC EN 301 489-1/-17

Article 3.2 Effective use of the spectrum EN 300 328

The conformity assessment for the Promi-ESD were completed in accordance

with the R&TTE Directive Annex IV procedures, and the EC Declaration of

Conformity is attached to this manual.

 Cautions regarding regulatory compliance when integrating the Promi-ESD

The person integrating the Promi-ESD becomes the manufacturer of the final

product and is therefore responsible for demonstrating compliance of the product

with the essential requirements of the R&TTE Directive.

In all cases assessment of the final product must be made against the Essential

requirements of the R&TTE Directive Article 3.1(a) and (b), safety and EMC

respectively, and any relevant Article 3.3 requirements

This device is intended only for OEM integrators under the following conditions:

1. This appliance and its antenna must not be co-located or operating in

conjunction with any other antenna or transmitter.

2. A minimum separation distance of 20 cm must be maintained between the

antenna and the person for this appliance to satisfy the RF exposure

requirements of the Council recommendation 1999/519/EC of 12 July 1999.