User's Manual

Promi-ESD User Manual – Appendix.E Regulatory Information E-7

 Conformity assessment procedures for final products exempted from R&TTE Directive Article 3.2

In every case, the manufacturer of a final product must follow the procedures for

conformity assessment of the final product with the requirements of R&TTE

Directive Article 3.1(a) and (b), for safety and EMC. The conformity assessment

for Article 3.2 is carried out in accordance with the following:

1) Attach the EN 300 328 test report of the assessed radio module and the EC

Declaration of Conformity to the conformity assessment of the final product (The

Declaration of Conformity is attached to the manual).

2) Specify on the conformity assessment of the end product that the assessed

radio module was integrated in the system without any changes, in accordance

with the installation directions of the manufacturer.

 Notification of the final product

Please note that this product, Promi-ESD01, uses radio frequency bands not

harmonized throughout the Community. The notification required by R&TTE

Directive Article 6(4) is necessary. It is the responsibility of the manufacturer of

the final product to notify the relevant national spectrum management authority

of the intention to place the final product on the market.

 CE marking

It is necessary to attach the CE mark to the final product to indicate that it

conforms with all the directives that apply to the final product. For model Promi-

ESD01, it must be given a Class Identifier (alert symbol) in addition to the CE

mark.

 Exemption clause

Initium Co., Ltd. does not guarantee the accuracy of the information above. In

case of doubt or uncertainty, we recommend that you check with the authorities

or official certification organizations of the relevant countries.