Installation Manual

Part Number IS1471

2002-06 Acura RSX

1- Intake system (SR)

1- 3” Injen/Amsoil Dry filter (#1017)

1- Heat shield (HS5000) (#11011)

3- Composite brackets (#4010)

1- 2 3/4” x 3” Step hose (#3011)

1- Power-Band (.040)(.312) (#4003)

1- Power-Band (.048)(.362) (#4004)

1- 1525 Sensor grommet (#6014)

3- 5/16 Flanged bolts (#6019)

1- 4 Page instruction

Note: The C.A.R.B Exempt sticker must be

attached under the hood in a manner such

that it is easily viewed by an emissions

inspector

Note: Parts and accessories are now

available on line at

“injenonline.com

”

Congratulations! You have just purchased the best engineered,

dyno-proven intake system available.

Please check the contents of this box immediately.

Report any defective or missing parts to the Authorized Injen

Technology dealer you purchased this product from.

Before installing any parts of this system, please read the instruc-

tions thoroughly. If you have any questions regarding installation

please contact the dealer you purchased this product from.

Installation DOES require some mechanical skills. A qualified

mechanic is always recommended.

*Do not attempt to install the intake system while the engine is hot.

The installation may require removal of radiator fluid line that may

be hot.

Injen Technology offers a limited lifetime warranty to the original

purchaser against defects in materials and workmanship. Warranty

claims must be handled through the dealer from which the item

was purchased.

Injen Technology 244 Pioneer Place Pomona, CA 91768 USA 91768

PAGE 1
Part Number IS1471 2002-06 Acura RSX 1- Intake system (SR) 1- 3” Injen/Amsoil Dry filter 1- Heat shield (HS5000) 3- Composite brackets 1- 2 3/4” x 3” Step hose 1- Power-Band (.040)(.312) 1- Power-Band (.048)(.362) 1- 1525 Sensor grommet 3- 5/16 Flanged bolts 1- 4 Page instruction (#1017) (#11011) (#4010) (#3011) (#4003) (#4004) (#6014) (#6019) Note: The C.A.R.
PAGE 2
place the 2 3/4” step hose on the throttle body and use two clamps >>>>> >> Use the stock 6 x 1.0mm bolt as seen here. Screw in just enough to hold in place. < << < Figure 3 Figure 2 Press the 1525 grommet into the pre-drilled 3/4” hole.
PAGE 3
Insert the 3/4” aluminum tube into the stock breather hose on the valve cover < << <<<<<<<< << << < Figure 11 Press the assembled filter and heat shield over the end of the intake and tighten the clamp. Injen Technology Research & Development Team seen here testing its final design on Injen’s own in-ground Dyno-jet.
PAGE 4
Note: Disconnect the negative battery terminal before installing this system. 1- Remove the air intake box and air intake duct leading to the throttle body. Remove the air temperature sensor and disconnect the vacuum lines connected to the box. Be very careful not to break or crack the plastic port where the vacuum lines connect. Do not remove any stock lines. 2- Place the Injen 2 3/4” step hose over the throttle body and use the two stock clamps. Tighten the clamp on the throttle body at this point.