Installation Manual

<<<<
PP
PP
ll
ll
uu
uu
gg
gg
<<<<
PP
PP
ll
ll
uu
uu
gg
gg
PP
PP
ll
ll
uu
uu
gg
gg
>>>>>
B
B
a
a
t
t
t
t
e
e
r
r
y
y
>
>
>
>
Page 2 of part# RD3015
Disconnect the sensor harness from the
mass air flow sensor.
The vibra-mount is screwed under the strut tower
mount brace (A). Mount the 2020 bracket to the
bottom side of the vibra-mount (B), Use flange nut.
(A)
(B)
>>>>
The stock air intake box and air intake
duct have been removed from the engine
compartment.
Use the zip tie to secure the harness away from the
intake.
Positioning the intake: As the intake is lined up to the
mass air flow sensor and inserted into the head lamp
area, the intake bracket is lined up to the fender wall
stud.
The intake is lower into the engine compartment and
lined up to the hose on the mass air flow sensor.
Press the top section of the intake into the 2 3/4” hose
located on the mass air sensor. position the intake but
do not tighten the power-band at this point.
>>>>
>>>>
<<<<<
under frame
Power-bands are used to secure the hose
in place, tighten the hose on the sensor.
Remove the plastic plugs (A) and lift the plastic
shrouds from the cross member (B).
>>>>
The 70mm straight hose is pressed over
the mass air flow sensor.
A screwdriver is used to remove three plastic plugs.
This is required in order to remove the resonator air
vent from the driver side head lamp.
The plastic resonator air vent is now removed form
the back side of the head lamp. Note: Steps 6 thru 9
may only apply to US applications
>>>>
<<<<<
under frame
Some models may require removal of the head lamp
in order to remove the air vent. The Circles represents
mounting points for the plastic plugs removed.
>>>>
under frame
>>>>
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12