Installation Manual

Page 3 of part# RD3015
Injen Technology Research & Develop-
ment team seen here testing its final
design on Injen’s own in-ground
Dyno-jet.
Injen proto-typed various types of
bends and tube size until peak power
was achieved.
Dyno-graph shows a 9.0 Hp gain at
high end. Torque shows 9.6 ft./lbs
at low to mid range.
The air pump pressure fit clip is pressed over
the machined air pump adapter until it snaps in.
All mounting points and air pump flex-line has been installed (Top picture).
The intake and filter is completely installed (Bottom picture).
The intake is pressed into the mass air
sensor hose as shown above.
The intake bracket is lined up to the 2020 bracket and
the m8 flange nut and bolt are used to retain the intake
in place.
The second intake bracket is lined up to the fender well
threaded stud. The m6 flange nut and fender washer
are used to secure the intake to the fender well.
The intake is pressed over the filter neck. Once
the intake is butted up to the built in filter stops,
continue to tighten the filter clamp.
>>>>>
>>>>
Figure 13 Figure 14 Figure 15
Figure 16 Figure 17
Figure 18
Figure 19
>>>>
>>>>