Owners manual

Part number SES1204DP
Part number SES1205DP
The SES1205DP comes with
catalytic converter
2008 Subaru Impreza WRX/Sti
2.5L Turbo
1-
GD76-P106 metal gasket (#17060)
2- m10 x 40mm bolts x 1.0 (#6038)
5- 10mm flange nuts (#6069)
2-
m8 x 40mm bolts x 1.25 (#6068)
2- 8mm flange nuts (#6017)
1- SES exhaust decal (#7027)
1- page instruction
Note:
Do to the sensitivity of the ECU,
some or additional engine tuning
maybe required to correct short
term fuel and timing trims.
SES1205DP- Full 76mm down pipe with catalytic
converter, stainless steel cast turbo bellow with
divided wastegate discharge.
SES1204DP- Full 76mm down pipe and stainless steel
cast turbo bellow with divided wastegate discharge.
2002-06 WRX 2.0L, 2.5L and 2004-06 STi 2.5L turbo
Kit comes complete with
nuts and bolts.
Note: The installation of this SES exhaust does require mechanical
skills. Removal of the stock parts does require
loosening and removing several parts and screws that may be difficult.
In addition, removing the stock
exhaust will also have to remove the air resonator box, battery and
tray when beginning this installation.
Injen strongly recommends that this system be installed by a
professional mechanic.
Congratulations! You have just purchased the best engineered,
dyno-proven stainless steel exhaust system.
Please check the contents of this box immediately.
Report any defective or missing parts to the Authorized Injen
Technology dealer you purchased this product from.
Before installing any parts of this system, please read the instructions
thoroughly. If you have any questions regarding installation please
contact the dealer you purchased this product from.
Installation DOES require some mechanical skills. A qualified
mechanic is always recommended.
*Do not attempt to install the intake system while the engine is hot.
The installation may require removal of radiator fluid line that may
be hot.
Injen Technology offers a limited lifetime warranty to the original
purchaser against defects in materials and workmanship. Warranty
claims must be handled through the dealer from which the item was
purchased.
Injen Technology 244 Pioneer Place Pomona, CA 91768 USA
Please check the contents of this box immediately.
Note: This intake system was Dyno-tested with an Injen filter and
Injen parts the use of any other filter or part will void the
warranty and CARB exemption number.
Parts and accessories are available on line at “Injenonline.com”
2008 WRX 2.5L, STi 2.5L turbo

Summary of content (1 pages)