Owners manual

Part number SP1111
2001-06 BMW E46
330i
3.0L L6 M54 Engine
Short Ram Intake System
1- 5” Injen dry filter (#1045)
1- 3-3/4” adaptor (#6049)
1- Heatshield (#11058)
1- Cover (#11059)
1- 3-1/2”x3-3/4” step hose (#3133)
1- Power Bands #056 (#4005)
1- Power Bands #064 (#4006)
8- M6 button head screw (#6083)
1- M6 vibra-mount (#6020)
1- M6 flange nuts (#6002)
1- M6 washers (#6010)
1- Vinyl trim @ 10”L (#6023)
1- Grommet (#8031)
1- 2 Page instructions
Note:
Injen strongly recommends
that this system be installed by a
professional mechanic.
All parts and accessories now sold
on-line at : www.INJENONLINE.COM
Injen Technology
244 Pioneer Place Pomona
CA 91768 USA
Congratulations! You have just purchased the best engineered, dyno-proven cold air intake system available. Please check the contents of
this box immediately.
Report any defective or missing parts to the Authorized Injen Technology dealer you purchased this product from. Before installing any parts of this system, please read the
instructions thoroughly. If you have any questions regarding installation please contact the dealer you purchased this product from.Installation DOES require some
mechanical skills. A qualified mechanic is always recommended.*Do not attempt to install the intake system while the engine is hot. The installation may require removal
of radiator fluid line that may be hot. Injen Technology offers a limited lifetime warranty to the original purchaser against defects in materials and workmanship. Warranty
claims must be handled through the dealer from which the item was purchased.
M.R. Technology
“The World’s First Tuned air Intake System!”
Factory safe air/fuel ratio’s for Optimum performance Patent# 7,359,795
Now equipped with “Air Fusion” Patent pending
“At Injen Technology, we didn’t copy the step down process, we invented it!”
Note: This intake system was Dyno-tested with an Injen filter and Injen parts. The use of any other filter or part will void the warranty. Parts and acces-
sories are available on line at “Injenonline.com
SP1111 PAGE 1-2
Warning: Manufactures attempting to duplicate Injen’s
patented process will now face legal action.
MR Technology Step down process:
1- Calibration Method for Air Intake Tracts for Internal Combustion Engines. Covered under Patent# 7,359,795
2- Calibration Device for Air Intake Tracts for Internal Combustion Engines. Published and patent pending
3- Calibration Method and Device for Air Intake Tracts having Air Fusion Inserts. Published and patent pending
Complete stock air box.
Figure 1
Disconnect MAF sensor harness. Un-clip the air box from
the MAF sensor. Pull back MAF sensor from the air box.
Figure 2
Loosen the 2-10mm bolts holding in the air box.
Figure 3
Pull back the snorkel scoop from the air box.
Figure 4
Carefully lift up and pull out the air box.
Figure 5
Remove the rubber isolator from the vehicle frame near
the alternator
Figure 6
A) install m6 vibramount to the threaded insert on frame
from step 5.
B) Secure and tighten the vibramount.
Figure 7
A
B
Install the Velocity stack adaptor to the inside of the heat-
shield.
Figure 8