Installation Manual

Diagram to help aid in the removal
of the front bumper.
<<< Arrows indicate where fasteners are located
Removal of the head light
is not required.
Washer reservoir removal
(A) remove the 2 pin
connectors and washer
tubes (B)
(C) Remove the 3 m6 bolts in order
to remove the reservoir tank.
<<< remove the long spout
down to the reservoir.
Diagram 1
Diagram 2
Front washer motor >>>
Rear washer motor >>>
C
Use 7.0 lbs.-ft. of torque
when replacing m6 bolt.
Remove the three m6 bolts holding the reservoir tank in place (A). Remove
the 2 pin connector pins from the two washer motors (B). Remove the stock
reservoir bottle from the car frame.
(A)
(A)
(A)
(A)
(A)
(A)
(B)
(B)
(B)
(B)
Once the tank has been removed cut a 4” x 5” open on both sides of the
splash guard. This will allow access to the bumper area for the filter.
Page 2 of Part# SP1477