Installation Manual

(A)
(A)
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
Note: It is extremely important that you hand tighten the m6 x m25 bolts and vibra-mount used to fasten the reservoir tank.
Hand tighten bolt and than turn 1/4 or 7.0 lbs.-ft. of torque. Too much torque will damage and cause the tank to leak.
This is the location of the vibra-mount prior to setting the reservoir tank in place.
The tank is placed under the vibra-mount, this is for demonstration of the location
only (A). The opening that leads into the engine compartment when installing the
intake(B).
(B)
(B)
The battery tray is removed from the RSX (A). Turn the battery tray upside down
and drill the two tacked or spot welded areas until the bracket becomes loose (B).
(A)
(A)
(B)
(B)
Once the bracket on the battery tray is broken loose(A) go ahead and reinstall
the battery tray back to its stock location (B).
(A)
(A)
(B)
(B)
Remove the stock motor grommets from the stock reservoir tank. Press the two
stock grommets into the pre-drilled 21mm holes in the new reservoir bottles.
Once the stock grommets have been pressed into the pre-drilled holes(A) take the
stock motors and press them into the stock grommets(B).
Remove the large spout grommet from the stock reservoir tank and press it into
pre-drilled hole in the new reservoir tank.
(A)
(A)
(B)
(B)
Position the new reservoir tank in the same stock location (A). Press the bottom
end of the stock spout into the large grommet on the tank(B).
Align the three holes in the reservoir tank to the three pre-tapped holes located
in the car frame. Screw the long stud on the vibra-mount over the reservoir tank
and into the pre-tapped hole until the tank is firmly fastened(A). Firmly press the
end of the spout into the grommet until a proper seal has been achieved(B).
(A)
(A)
(B)
(B)
(A)
(A)
(B)
(B)
Page 3 of Part# SP1477