Owners manual

Once the tension clamp as been pulled back, pull the
crankcase vacuum hose from the air duct port.
An allen screwdriver is used to loosen the two stock
screws from the mass air flow sensor.
Prior to starting the installation, Disconnect the negative bat-
tery terminal.
Figure 3
Page 2 of Part# SP1832
Figure 11
Once you have loosened the plastic clips, continue to
pull up on the clips as shown above.
The air scoop is dislodged and pulled from the open-
ing of the air box cleaner as shown above.
The m6 bolt is loosened from the base of the air box
cleaner.
The tension clamp is compressed and pulled from
the crank case vacuum hose located over the air
intake duct.
Figure 8
Figure 9
Figure 5
Figure 7
Figure 4
Figure 13
Figure 6
Figure 10
Figure 12
Pull up on the air scoop and pull forward in order to
dislodge the air scoop from the air box cleaner.
Once you have loosened the m6 bolt, continue to pull
the m6 bolt out.
Depress the clip on top of the harness and pull the
harness away from the mass air flow sensor.
A phillips screw driver is used to loosen the two plastic clips.