Owners manual

The two mass air flow sensor screws are loosened
and removed in order to pull the sensor out of the
sensor housing.
The air duct clamp is now loosened from the throttle
body.
The air duct is now ready to be pulled off the throttle body.
Shot of an empty engine compartment with no air intake box or air intake
duct.
Once you have positioned the hose in place, continue
to tighten the hose clamp located over the throttle
body.
The stock air intake box and air intake duct is now pulled out of the engine
compartment.
The 2 3/4” silicone elbow is pressed over the throttle body along with the
clamps.
The extension bracket is now in place, semi-tighten
the clamp for now.
Figure 20
Figure 17
Figure 18
Figure 16
Figure 14
Figure 21
Figure 19
Page 3 of Part# SP1832
Figure 15
The mass air flow sensor is now pulled out of the
sensor housing.
Figure 22
The extension bracket is placed over the pre-thread-
ed hole that once held the air box cleaner in place.
An m6 bolt and washer is used to fasten the bracket
in place.
Figure 23