Owners manual

The vibra-mount is aligned to the end of the exten-
sion bracket and inserted into the hole.
An m6 flange nut is used to fasten the vibra-mount to
the end of the extension bracket.
The vibra-mount is now installed as shown above.
The assembled filter and intake is now lowered into
the engine compartment.
Once the filter has been properly adjusted, continue to
tighten the filter clamp.
The filter is now aligned to the end of the intake.
.The m6 flange nut and washer is used to fasten the
intake bracket to the vibra-mount stud.
As the intake is inserted into the throttle body hose
the intake bracket is aligned to the vibra-mount stud.
The lower end of the intake is inserted into the throt-
tle body hose.
Once you have aligned the intake continue to tighten
the hose clamp located over the intake,
The m6 nut is now tightened over the extension brack-
et.
The fitment is checked again prior to tightening the m6
flange nut on the intake bracket and vibra-mount.
Page 4 of Part# SP1832
Figure 24
Figure 30
Figure 28
Figure 27
Figure 26
Figure 25
Figure 32
Figure 31
Figure 29
Figure 35
Figure 34
Figure 33