Installation Manual

Take the vibra-mount and screw it into fender wall. Turn the vibra-mount into the
fender wall until it bottoms out.
Insert the top end of the intake into the throttle body hose. Semi-tighten the
other power-band just enough to hold the intake in place.
The bracket used to hold the stock air box in place will no longer be used.
Remove the stock bracket to make room for the m6 vibra-mount. New location
for the vibra-mount (A).
Press the 3 1/8” straight hose over the throttle body and use two .362 power-
bands on the hose. Tighten the band located over the throttle body at this point.
Loosen clamp at the throttle body and remove the air intake duct. At this
point, it will be necessary to remove the front bumper. Remove 9 clips on
top of the bumper, two 10mm screws on each side of the bumper , four
additional sheet screws and 5 plastic clips.
Once the bumper has been removed continue to disconnect and remove the
plastic air intake resonator box.
Remove plastic expanding plugs holding the front air
scoop over the radiator. Once all plugs have been
removed, continue to remove the air scoop.
Loosen clamps and remove bolts from the stock air
intake box cleaner in order to remove the entire air
cleaning assembly.
>>>>
>>>>
>>>>
(A)
>>>>
Page 2 of Part # SP1978
Remove the four m6 bolts that secure the engine
cover over the intake manifold. Once all bolts have
been removed, continue to remove the engine cover.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10