Installation Manual

Press the top end of the intake into the primary hose (A). Align intake bracket to the

vibra-mount stud (B). Adjust secondary intake and semi-tighten band(A). Place fend-

er washer and m6 flange nut over the vibra-mount stud without tightening yet (B).

Align entire assembled intake and use a Ratchet or nut driver to tighten the m6

flange nut to the vibra-mount.

Use the stock screws to secure MAF sensor to the

MAF sensor adapter (A). Insert MAF sensor harness

plug over the sensor clip as shown above (B).

Carefully, lower the secondary intake into the resonator

opening and into the bumper corner.

Press the stock breather hose over the open CCV box port

as shown above.

Take the MAF sensor and insert it into the

machined MAF sensor adapter.

Insert the 1 1/8” CCV hose over the CCV box large port. Use the mini-bands to

secure the hose in place, tighten the band on the CCV box port at this time.

Press the assembled CCV box over the large intake port as shown above (A).

Adjust entire CCV box and the tighten mini-band on the intake port (B).

Use the torx bit in this kit to unbolt screws from the

MAF sensor. Carefully, remove the MAF sensor

from MAF sensor housing.

Press the 3” straight hose over the end of intake and

tighten band located on the intake side. The second

band is not tightened yet (A).

CCV box

CCV hose

>>>>

(A)

(B)

(A)

(B)

>>>>

(A)

(B)

Page 3 of Part # SP1978

Fig. 11

Fig. 12

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Fig. 17

Fig. 18

Fig. 20

Fig. 19

>>>>