Installation Manual

Press the 3 1/8” straight hose over the throttle body and use two medium .362
power-bands, tighten the clamp on the throttle body at this point.
Take the primary intake and position it in place. The first step is to press the
crankcase breather hose over the 5/8” port on the intake. Continue to align the
entire intake by following the next steps of the instructions.
Prior to installing the cold air intake the front bumper will need to be removed.
See next page diagram (A) for instructions.
Screw the vibra-mount into the pre-tapped mounting point of the intake manifold.
Screw the vibra-mount in until it is firmly in place.
Remove the MAF sensor from the sensor housing. The sensor housing will no
longer be used in this application.
The entire air intake box, duct and sensor housing is removed in one piece(A).
Before removing the air intake box from the engine compartment, disconnect the
breather line connected to the box and crankcase (B).
Loosen two nuts and remove the plastic intake manifold cover before installing
the intake.
The front air scoop is removed in order to make room for the silicone intake
hose.
(B)
(A)
<<<<<<
Page 2 of Part# SP1986
Fig 2
Fig 3
Fig 6
Fig 7
Fig 8
Fig 9
Fig 4
Fig 5