Installation Manual

The cold air intake is seen in this picture used as a short
ram.
Slip the secondary silicone into the air scoop opening
and point the front end down towards the front of the
radiator.
The two stock screws are now securing the MAF sensor to the adapter (A). The
harness clip is pressed over the sensor until it snaps in place (B).
Once the entire intake is aligned and secured in place the intake manifold cover
is re-attached.
Once the intake is aligned use the m6 flange nut and fender washer to secure
the intake in place.
Press the stock MAF sensor into the machined adapter welded to the intake and
use the stock screws to secure the sensor in place.
The crankcase breather line is attached to the intake port and the stock clamp is
used to secure the line in place.
Press the top end of the intake into the hose on the throttle body (A) while
aligning the bracket on the intake to the vibra-mount stud (B).
The 3 1/2” top end of the hose is pressed over the
primary end of the intake. Use one .412 large
power-band to secure the hose in place.
<<<<<<
(A)
(B)
<<<<
(A)
<<<<
(B)
Page 4 of Part# SP1986
Fig 10
Fig 11
Fig 12
Fig 13
Fig 14
Fig 15
Fig 17Fig 16
Fig 18