Installation Manual

Take the final piece of the intake slip it through the
bottom bumper(A). Slip the intake into the end of the
silicone intake and use the .362 power-band to secure
intake in place (B).
Line up the pre-tapped hole on the bumper reinforce-
ment to the intake bracket. Use the stock plastic clip
to secure the intake in place.
The plastic clip is shown here locating the intake to
the bottom of the bumper reinforcement.
1. Once the installation is complete, reconnect the negative battery terminal before you start the engine.
2. Align the entire intake system for the best possible fit. Once the intake has been properly fitted continue
to tighten all nuts, bolts and clamps.
3. Periodically, recheck the alignment of the intake system and make sure there is proper clearance around
and along the length of the intake. Failure to follow proper maintenance procedures may cause
damage to the intake and will void the warranty.
4. Start the engine and listen carefully for any odd noises, rattles and/or air leaks prior to taking it for a test
drive. If any problems arise go back and check the vacuum lines, hoses and clamps that maybe causing
leaks or rattles and correct the problem.
5. Check the filter for excessive dirt build up. Clean or replace the filter with an original Injen filter (can be
bought on-line at “injenonline.com”). Congratulations! You have just completed the installation of the
best intake system sold on the market. Enjoy the added power and performance of your new intake
system.
(A)
(B)
The 3/12” filter is placed over the
end of the intake. The clamp on the
filter neck is tightened to hold the
filter in place (A).
Check the entire intake track for
best possible fit. Once the intake
has been cleared from any rubbing
parts continue to tighten all nuts,
bolts and clamps. Congratulations,
You have just completed the instal-
lation of the this cold air intake (B).
(A)
(B)
Page 5 of Part# SP1986
Fig 19
Fig 20
Fig 21
Fig 22
Fig 23