Owners manual

Vibramount shown mounted to chassis
Now remove the second air pump line
Place the M8 vibra mount into the 1/2” hole located
on the frame under the driver side headlight. Use
the headlight in the photo for reference. Use a
3/8”washer and M8 nut to secure the vibramount to
the chassis
With the pressure clamp loose pull the air duct off the air
box
Firmly lift up on the air box/engine cover and remove
from the engine bay
Picture of factory air intake system
Use a T20 torx screw driver and remove the two torx
screws holding the front air box inlet.
Locate the two air pump lines connect to the throttle
body air duct. First disconnect the larger one by firm-
ly pressing on the two release tabs and pulling out.
Use a channel lock plier to loosen the pressure clamp
on the throttle body and remove the plastic air duct
from the throttle body.
Page 2 of Part# SP3027
Use a channel lock plier to loosen the pressure clamp
on the air air box
Figure 3
Figure 4
Figure 5
Figure 6 Figure 7
Figure 8
Figure 10
Figure 9
Figure 11
Figure 12
Air pump line 1
Air pump line 2
Driver side headlight
1/2” hole
Drop the intake tube into the engine bay and put the
filter end of the pipe into the bumper cavity under
the driverside headlight. Position the other end into
the 3.0” coupler on the throttle body
Place the 3.00” straight hose and 2 48 clamps onto
the throttle body
Figure 13 Figure 14