Instructions / Assembly

Step 1. Assemble the lounge on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.

Attach seat cushion (P2) to back frame (P1) as shown below. Loosely tighten the bolts with Allen wrench (H5).

Assembly Procedures:

Pre-assembly:

Take out all parts and hardware from box.

Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.

Important safety instructions:

Please read carefully all instructions before assembly.

For your safety and ease, assembly by two or more adults is recommended.

Keep instructions for future use.

DISCLAIMER:

WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES

RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.

PAGE 1
Important safety instructions: Please read carefully all instructions before assembly. For your safety and ease, assembly by two or more adults is recommended. Keep instructions for future use. Pre-assembly: Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware. Take out all parts and hardware from box. H1 H2 H3 H4 H5 H6 DISCLAIMER: WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE.
PAGE 2
(H5)x1 H5 P1 Step 3. 1) Insert the dowels on the ends of front stretcher (P5), then attach the front stretcher (P5) between right arm (P3) and left arm (P4). 2) Loosely tighten right arm (P3) to the front stretcher (P5), seat cushion (P2) and back frame (P1) as shown below.
PAGE 3
(H5)x1 P4 P5 Step 5. 1) Make sure the assembled lounge is level and s ecurely tighten all the bolts with Allen wrench (H5). 2) Attach wooden plugs ( H6) to each exposed bolt holes, tighten with rubber hammer to knock the wooden plug till its tighten. Note: use a soft cloth between the wooden plug and hammer to prevent damage to wooden plug finish. 3) Assembly is complete. Failure to follow these instructions may cause the bolts to misalign during assembly.