User Guide
Setting target temperature SV=150
Keep the Default value
Sn=20 (CU=20, more detail please check
6.9.1)
Setting Alarm value for
high limit
Setting Control mode
Setting Input sensor
value
Initial display
︽
Keep the Default value
Keep the Default value
Keep the Default value.
2:Heater, 3:Cooler
Setting Revise
displayed value
Setting Alarm
definition
Setting System
functions selection
Setting HIRL=160, more setting of alarms,
please check 6.8.1
*if don't need to set this parameter, press
SET key to run into next setting.
Keep the Default value
Keep the Default value
Setting Permission of
revising parameter
8 definitions for field
parameter
Figure 15:Workflow of sample
Power On
SET
SET
SET
SET
SET
SET
SET
SET
SET
9
© 2015 Inkbird Inc. All rights reserved.
www.ink-bird.com, CS@ink-bird.com