User's Manual

1. Make sure that your phone is not connected to a 5GHz Wi-Fi network. This device
only supports 2.4GHz Wi-Fi networks.
2. Make sure you enter the correct Wi-Fi account and password.
3. Enable your phone’s location services to allow the app to access your location. If
the app is unauthorized, the device cannot connect with your phone.
4. Put your phone as close to the device and router as possible.
5. The device power cannot be too low when configuring a Wi-Fi network.
6. Reset the device and router.
7. Press the button and hold for 3 seconds to reset Wi-Fi or change the Wi-Fi
FAQ (frequently asked questions)
05
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
What if your phone can't connect to Wi-Fi networks?
connection mode if the Wi-Fi icon doesn’t flash. It will take 5 seconds to implement
the action. The Wi-Fi icon will flash quickly in SmartConfig mode and slowly in AP
mode.
8. VPN and network proxy servers are not used during connection processing, as
they may cause connection failure.
9. Check your router settings. The device may be blocked or blacklisted.
10. See 2.2 above for details.
residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator & your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
23