User's Manual

JUNI JF43-E1900/CFN03
CDMA FIBER FED REPEATER OPERATIONS MANUAL
Version 1.17 ⓒ J
uni America Inc. Page 52 of 88
Similar to the Donor-0 Status window (Figure 4.7), the Remote-0 system status may
be monitored by the color indicated beside each of the alarm contents.
Note: only dissimilar items from the Donor-0 status window are outlined below.
1. PA
① Over Power: Displays the Over Power alarm state of the Power Amplifier
② VSWR: Displays the VSWR alarm state of Power Amplifier
③ Link Fail: Displays the alarm state of the Link between RSM and Power Amplifier
④ Over Temp: Displays the Over Temperature alarm state of the Power Amplifier
⑤ DC Fail: Generates alarm when the power supply of the Power Amplifier detects a
fault in its circuit
⑥ PA On/Off: Displays the ON/OFF state of the Power Amplifier
⑦ Type: Displays the capacity of the Power Amplifier
⑧ PA On/Off: Controls the ON/OFF function of the Power Amplifier
2. Forward output power
① Hi Power: Displays the High Power alarm status. Alarm generated when the
detected temperature of the RU exceeds the set ‘Upper Limit’
② Lo Power: Displays the Low Power alarm status. Alarm generated when the
detected temperature of the RU is below the set ‘Lower Limit’
③ DL ATT: Displays the Downlink (Forward) Attenuation. Attenuator that controls the
final downlink output
④ Output pwr: Displays the current output power
⑤ Upper limit: Displays the Upper limit output value
⑥ Lower limit: Displays the Lower limit output value
⑦ Power Limit: Controls the On/Off function of the Power Limit
⑧ Pwr Lmt Val.: When the Power Limit is turned “On”, it adjusts the DLATT (Downlink