User's Manual

JUNI JF43-E1900/CFN03
CDMA FIBER FED REPEATER OPERATIONS MANUAL
Version 1.17 ⓒ J
uni America Inc. Page 62 of 88
The HyperTerminal should now be ready to accept user input from the keyboard.
Once the PC is connected to and can access the MCU, it will display a LINUX
command shell such as the figure below.
[Figure 4.24] MCU Start-up Screen Output
If the screen is blank, press the enter key and a tilde pound (to #) command will be
displayed. This means that the MCU is ready to accept input.
Please refer to the next section to view and alter settings on the MCU.
4.3.3 View and Change SNMP Destination IP
To view and change the SNMP destination IP, the PC should be connected to the
MCU via a RS232C cable. With the “to #” command displayed, type in “snmptool” to
display the following menu.
Note: Any changes made other than the ones listed below can prevent the
SNMP from functioning properly.