User Manual

12
4. Frequency Band Setting
Once the location and positioning of the Antenna Unit and Coverage Unit are finalized, the
authorized installer should proceed with installing the Antenna Unit and Coverage Unit. But
first, the installer should set the appropriate operating frequency band(s) for the repeater,
based on Verizon Wireless licenses. The figure and table below show the DIP Switch settings.
Usually both PC S and C ellular bands have to be set up.
Î DIP Switch Functions
Fig. 5 DIP S/W 기본 S etting
PIN NO. FUNC TION STATUS
1 Cellular Band Selec tion
ON : Cellular B Band
OFF : C ellular A Band
2
3
4
5
6
7
PCS Band Selection See the next tables below
8 PCS EVDO OF FS ET
ON : PCS Gain OFFSET 3dB(increase) ON
OF F : PCS Gain OFFS ET 3dB(reduction) OFF
9 Cellular EVDO OFFSET
ON : Cellular Gain OFFS ET 3dB(increase )ON
OF F : C ellular Gain OFFS ET 3dB(reduction) OFF
10 Band Selection Mode
ON : Software Band Selection Mode
OF F : Hardware Band S election Mode
11 Uplink RF OFF
ON : Reverse RF Power OFF
OFF : Reverse RF Power ON
12 Hardware Reset
ON : Reset
OFF : Normal Operation
PIN NO. FUNC TION STATUS
1 PCS PATH HARDWARE ON/OF F
ON : PC S UL/DL PATH HARDWARE ON
OF F : PCS UL/DL PATH HARDWARE OFF
2 CELLULAR PATH HARDWARE ON/OFF
ON : CELLULAR UL/DL PATH HARDWARE ON
OFF : CELLULAR UL/DL PATH HARDWARE OFF