Printer Accessories User Manual

1. Insert the cartridge into the refill clip completely. Place the
sponge side of the cartridge first and then press down the opposite
side .until you hear it clicking into place
2. Open the cap of the ink container and connect the ink injection
needle. As shown in the figure, turn the refill clip upside down so
that the bottom part faces upward.
3. Insert the ink injection needle into the hole of the refill clip tank, and
inject 2ml of ink. Wait 1 to 2 minutes
with the
supplied rubber plug
until the ink is completely absorbed
into the sponge inside the cartridge, and then close the hole again
If you inject too much ink, it may flow over or leak out.
.
Warning:
4. As shown in the figure, turn the refill clip and with a
sharp tool such as a knife, cut out the sticker attached on the top of the cartridge in
a round shape. With the supplied gimlet, take out the ball to create an ink injection
inlet.
Take special care not to hurt yourself when you use a sharp tool such
as a knife.
back to upright position
Warning:
Inktec Refilling Instructions for
Canon CLI-521BK
Black Ink Cartridge
(BKI-9021D)
designed to work with genuine Canon cartridge only
INKJET
O N L I N E
5. Slowly inject of ink into the ink injection inlet for about ,
and then completely close the ink injection inlet
.
The ink volume specified above is for a completely empty
cartridge.
If you inject too much or too quickly, it may flow over or leak out.
5ml 20 seconds
with another rubber
plug
Warning:
Warning:
6. Remove the cartridge from the refill clip and clean the excessive ink around the nozzle,
the nozzle part of the cartridge on some sheets of soft tissue. Then install it in the
printer.
If the ink keeps on leaking out of the cartridge nozzles after refilling or the printout
quality is not good enough, read the "Emergency measures when problems occur after
refilling" at the end of the user manual and take the right step.
dabbing
Note:
7. Change as below:
When the window of appears:
- Click the or button on your printer
- When the window of appears, follow the procedures Case 2 below.
Case 2: When the window of appears:
- Click the button on the window.
- When the message of appears, press and hold the
or button on your printer for 10 seconds.
Before using the printer, run the process.
The level warning system of the refilled cartridge will be deactivated permanently. Refill the
cartridge only when the print quality begins to deteriorate and the cartridge is actually out of ink. If you keep
on printing without inks for a long time, the print head will be damaged.
the printer setup
Case 1: "ink is running low"
"OK" "out of paper"
"ink has run out"
"ink has run out"
"yes"
"Press and hold the Stop/Reset" button....
"Stop/Reset" "out of paper"
"head cleaning"
Warning:
5ml
2ml