Quick Guide
OVERVIEW Receiver Scan Light Scan Power Light Scan Power Button Return Scan Enter F1 Key F2 Key Delete Microphone Speaker Scan window Type-C interface HOME Flash lamp Camera Card Reading area Power Button Battery cover Hot button/Custom button 1. Screen capture: "power"+"Volume -" 2. Custom button: Setting → Feature → Custom Key 3.
STRAP INSTALLATION Buckle (As Pic1) Following the direction of the above arrow, push the strap buckle up to secure it.
OPEN THE BATTERY COVER 1. Push the battery cover button in anti-clockwise direction. (As Pic1) 2. Pull out the battery cover by using the hand position between the battery cover and the bottom case. remove the positive and negative insulation yellow * Please sticker on the battery before turning on tne device.
REMOVING-THE BATTERY 1. Lift the strap on the battery: 2. Pull the battery belt to take the battery off on 45° obliquely upward.
INSTALL TF/SIM CARD 1.
EQUIPMENT CHARGING DEVICE CHARGING: 1. Pull out the waterproof USB plug on the right side with the Type-C USB cable that comes with the device.Insert the Type-C USB cable. Type-C interface 2. Use cradle to charge. (Cradle comes seperately) 1. Battery is fully charged after 4 hours of charging, and the standby time is over 48 hours. 2. Cradle can charge 1 battery and 1 terminal simultaneously. 3. The left indicator light is the battery charging indicator, when the battery is charging, it will appear red.
SCAN(OPTIONAL) IF PDA COMES WITH SCAN FUNCTION, OPERATE AS BELOW: 1. Find the "scanner" app, and open it.(As Pic 1) 2. In the scan interface, press scan button to scan the barcode.
NFC(OPTIONAL) IF PDA WITH NFC FUNCTION, OPERATE AS BELOW: 1. Find the “NFC" app, and open it.(As Pic 1) 2. In the NFC interface, please read the card by NFC reading area.
OTA(UPDATE ONLINE) OUR PDA SUPPORT OTA(UPDATE ONLINE)FUNCTION,YOU CAN UPDATE THE LATEST FIRMWARE BY OTA, OPERATE IT AS BELOW: 1. Select "Settings"- About phone. 2. Press "System update" and enter into the updating firmware interface. 3. Press "Check now" to update the OS.
FAQ: 1. How to restore factory settings? Select “Setting”→“Backup&reset”→“Factory date reset" 2. Can’ t start PDA? (1) If the new device does not turn on, please make sure the sticker on battery has been removed. (2) Pressing the power button need about 4s, so press the power button untill the screen showing contents. (3) Check the if the battery have power, put the battery to PDA and charge it, if the screen shows charging icon, charge the PDA for some time and restart it. 3.
COMMITTED TO THE WORLD OF THINGS CREATING A SMART LIFE
