User's Manual

Operation

Wireless Mic Setup

To use the included wireless mic, follow these setup steps:

1. Ensure 2 new AA alkaline batteries are installed in the wireless mic (see the battery installation

side graphic). The microphone handle unscrews clockwise to reveal the battery compartment.

Screw the handle back on with the threads facing inward.

2. On the UHF Receiver panel on Envoi, turn on Power-Vol knob clockwise.

3. Turn on the wireless microphone using the switch found on the bottom of the microphone.

Watch the AF indicator to make sure a signal is being received.

4. Use the Up or Down buttons to select a wireless channel that gives a strong signal shown by

the RF LED lighting up.

5. Speak into the microphone and the AF LED will illuminate when speaking. Adjust the Power-

Volume knob to increase the level.

Note: If needed, the High/Low (H/L) switch on the wireless mic (see the side graphic) can be

adjusted to increase the signal range. The High power setting gives better range and

reception, but lower battery life. The Low setting provides better battery life but a narrow

signal range.

Note: If needed, the gain adjustment on the microphone can be adjusted clockwise for

more output gain. For less output gain, the screw can be adjusted counter-clockwise.

Mute Level

In most situations this should be left at the factory preset position. However, in cases of

high RF activity, the mute levels can be re-adjusted to compensate for adverse

conditions in a particular location. If the AF or RF LEDs flicker or stay on when the

wireless microphone is off, the Mute Level screw on the UHF receiver panel should be

turned counter-clockwise until the LEDs are off. When the Mute Level is properly

adjusted, the corresponding AF and RF LEDs will light up only when the wireless

microphone is being used.

Setting ASC (Auto-Sync Channel)

If you receive interference or if another channel is needed, select another channel

using the ASC (Auto-Sync Channel) button.

1. Select the UHF channel you want to use with the best reception using the Up

or Down buttons.

2. Turn the microphone on and place the microphone’s sensor (found above the

battery compartment, seen in the graphic above) near Envoi’s IR LED.

3. Press the ASC button once on Envoi and wait for about 3 seconds, until the IR

LED stops flashing. When it finds an interference-free channel, the wireless mic

will be matched to that channel.

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.

2. Power on Envoi.

3. Navigate to your Bluetooth device’s setup screen, find “Bluetooth”, and connect.

4. Play music from your Bluetooth device.

5. Adjust the volume from Envoi by holding down the |<< or >>| button to decrease or increase the volume.

6. To disconnect pairing, turn off Bluetooth on your device or select “Delete paired info” from the Envoi

Bluetooth menu.