Universal Docking Station with 2.
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture The unit should not be used near water.
LOCATION OF CONTROLS DOCKING STATION: Front View Backside Bottom View 3
REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 Volume Rotary Knob Speaker LED Indicator Speaker Speaker Detach Button Skip - Button Power on Indicator/Remote sensor Play/Pause button Skip + Button iPhone/iPod Connector DC 9V Jack RCA Video out Jack Aux-In Jack 14 15 16 17 18 19 20 21 22 23 24 Power On/Standby Function button Menu button Mute button Repeat button Random Button UP button Enter button VOL- Button Down button VOL+ Button Combination dead bolt POWER SOURCES 1.
To use the remote control, please ensure the remote control battery CR2025 (included) is installed properly and take the insulation clarity paper out.(Once you stop to use the remote control, pis. Insert in it same as before). Replace the remote control battery when it stops working. It is highly recommended to use a good quality button cell. Note: Room lighting and battery life can affect the operating range of remote control.
Connect the iPod to the base, the unit will play automatically. Once you take the iPod out, the unit will be Aux-in status. 2. The unit LED indicator (8) instruction. Once the LED indicator is red, it’s Aux-in working. Once the LED indicator is red, it’s iPod working. 3. The speaker LED indicator (2) instruction 1) When charge up, and the volume bottoms are closed, the LED indicator is red. Once full charge, it turn to blue.
TROUBLESHOOTING GUIDE Should you experience difficulties in the use of this player, please refer to the following chart. Symptom The base does not switch on (no power) Possible problem AC adaptor is not plugged into a wall outlet or the connector is not plugged into the DC jack on the back of the unit. Wall outlet is not functioning. Using no/wrong iPod cradle. iPod does not respond to the speaker system iPod is not installed properly. Your iPod is locked up.
SPECIFICATIONS Power Supply Power adaptor (included): Input AC 100-240V ~ 50/60Hz Output DC 9V 2A Power of remote control: 1 xDC 3VCR2025 button cell (included) Frequency RF Channel Transmission: 2.4GHZ This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
