User's Manual

5
Rear Panel
1. Battery Compartment – Insert 2
AAA batteries here to power the
receiver.
2. On/Off Switch – Slide this switch
to power the receiver on.
3. Power Input – Connect the
included 5VDC, 1A Center-Pin
Positive adapter power adapter here.
4. Antenna – Place the antenna in a vertical position for best results in transmitting the wireless
signal. If the wireless signal quality is poor, change the position of the antenna.
Troubleshooting
No signal:
• Make sure both the transmitter and receiver are powered on.
• Make sure you are within the 60-foot (20-meter) transmitting range.
• Make sure the transmitter and receiver have been paired.
• Make sure the volume controls on your mixer and speakers are turned up.
• Check the power LEDs on both the receiver and transmitter. If one of them is off, check that the
device is powered correctly:
o Connect the power adapter to (or install fresh AAA batteries in) the receiver.
o Make sure the transmitter has been charged.
Weak signal:
• Make sure there are no objects (computers, walls, furniture, etc.) between the transmitter and
receiver.
• Make sure you are within the 60-foot (20-meter) transmitting range.
• If the receiver is being powered from batteries, install fresh AAA batteries.
Poor signal quality:
• Keep any connected audio cables away from the receiver’s antenna.
• If the receiver is being powered from batteries, install fresh AAA batteries.
1
2
3
4
5
1
2
3
4