Operation Manual

108
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000.CONCEPT 4000.
CONCEPT 4000. User Manual.
Wireless Remote Fob Operations.
Some sytems may utilize Wireless RF Remote Fobs to perform Area control, Auxiliary
control, and Alarm functions. Any Fobs to be used in the system must first be enrolled
by being registered to individual Users. See “RF Fob Registration”, MENU, 2, 7.
COMPATIBLE FOBS.
- Paradox (Available in Concept 3000/4000 Firmware V7.62 or later)
REM1 (4-button), REM2 (5-button) and REM3 (15-button)
- Visonic (Available in Concept 3000/4000 Firmware V5.1 or later)
MCT-234/MCT-234W (4-button) and MCT-231/MCT-231WP (Single-button)
NOTE: At least one of the appropriate type of RF Expander Module must be
installed in the system in order to utilize Wireless Remote Fobs.
The Fob button functions are then defined in User programming. For ease of operation,
Fob functions will normally be programmed to be similar for all Fob Users in the same
system. However, as the system allows the function of each button to be individually
programmed for each User, the system also offers the flexibility for different Fob functions
to be defined for different Users. See “User Programming”, MENU, 2, 1.
In consultation with your Installer, use the following pages for planning and
recording the Fob button operations for your system.
FOB OPERATIONS.
Fobs can be programmed to perform the following operations:
- 1 button Arming.
- 2 button Arming.
- 1 button Disarming.
- 1 button Auxiliary On.
- 1 button Auxiliary Off.
- 1 button Auxiliary Toggle.
- 1 button Zone Alarm.
- 2 button Zone Alarm.
- Any 1 button action with
PIN code validation.
A single button is used to Arm one or more Areas.
A “Qualify” button must be pressed, followed by the
Arm button within 10 Seconds.
A single button is used to Disarm one or more Areas.
A single button is used to turn an Auxiliary On.
A single button is used to turn an Auxiliary Off.
A single button is used to change the state of an
Auxiliary.
A single button is used to trigger a Zone Alarm
(e.g. Panic, Duress, Medical Alert, etc).
A “Qualify” button must be pressed, followed by the
Zone Alarm button within 10 Seconds.
Any of the single button actions above followed by
the Fob User’s PIN code. (Paradox REM3 only)