InnerWireless, Inc. Richardson, Texas InnerWireless Access Point Interface COPYRIGHT© 2003 InnerWireless ALL RIGHTS RESERVED All information set forth in this document and all rights in and to intellectual property disclosed herein are the exclusive property of InnerWireless. No disclosure of this document and/or the information contained herein shall be made to any other person or organization without the prior written consent of InnerWireless.
Table of Contents Table of Contents ........................................................................................................- 2 1 FRONT CHAPTER...............................................................................................- 3 1.1 POLICY FOR INNERMOBILE® SYSTEM WARRANTY AND SUPPORT SERVICES ..............................................................................................................- 3 1.2 TO RETURN EQUIPMENT FOR REPAIR: .......................................
1 FRONT CHAPTER 1.1 POLICY for InnerMobile® System Warranty and Support Services 1.1.1 INNERMOBILE® SYSTEM STANDARD WARRANTY InnerWireless, Inc. warrants, for a period of one (1) year beginning upon the sign off of the InnerWireless Acceptance Test Procedure (ATP) for the identified InnerMobile® System provided herein, to be free from defects in materials and workmanship, and will operate and conform according to the product specifications.
InnerWireless for the individual unit of products or service or part thereof which gives rise to the cause of action or claim. 1.2 TO RETURN EQUIPMENT FOR REPAIR: • • • • Be able to communicate to InnerWireless the nature of the problem with the equipment Provide to InnerWireless your specific company name, ship to address, contact name and phone number. Call the customer service center to set up appropriate return address, per the component being returned for repair.
1.5 PRECAUTIONS PERSONAL AND EQUIPMENT SAFETY • • • Changes or modifications to this device not expressly approved by the manufacturer could void the user’s authority to operate the equipment. Refer to the User’s Manual supplied by Cisco Systems, Inc. for information on the Access Point usage and installation. Disconnect both power sources before servicing any equipment.
3 802.11 ACCESS POINT CONNECTION TO WDS SYSTEM 802.11 access points (AP) will be interconnected to the InnerWireless WDS system via a custom Access Point Interface. The installation requires no special tools or installation techniques. The most important item to remember is interconnecting the access point via the correct port of the Access Point Interface (labeled 2.4GHz port). Figure 1 depicts an interconnection diagram.
The 3 basic network configurations are; ! Warning TO COMPLY WITH FCC RF EXPOSURE COMPLIANCE REQUIREMENTS, ANTENNAS USED FOR THIS PRODUCT MUST BE FIXED MOUNTED ON INDOOR PERMANENT STRUCTURES, PROVIDING A SEPARATION DISTANCE OF AT LEAST 20 CM FROM ALL PERSONS DURING NORMAL OPERATION. Discone Access Point Interface 50 Ohm Term. Bandpass filter 400 – 2170MHz Cisco 1200 Access Point Bandpass filter 2400 – 2485MHz ½” Radiating cable, 10 ft.
LPA 50 Ohm Term. Access Point Interface Bandpass filter 400 – 2170MHz Cisco 1200 Access Point Bandpass filter 2400 – 2485MHz 4 meter jumper cable RP-TNC to N cable Basic configuration with a 4 meter jumper cable and LPA antenna PCB LPA Access Point Interface 50 Ohm Term.
