User's Manual

3 802.11 ACCESS POINT CONNECTION TO WDS SYSTEM
802.11 access points (AP) will be interconnected to the InnerWireless WDS system via a
custom Access Point Interface.
The installation requires no special tools or installation techniques. The most important item to
remember is interconnecting the access point via the correct port of the Access Point Interface
(labeled 2.4GHz port). Figure 1 depicts an interconnection diagram. Also note that a Reverse
Polarity TNC to N-Male jumper cable is used to interconnect the access point to the Access
Point Interface.
50 OHM
TERMINATION
REVERSE POLARITY TNC
802.11
MALE TO N MALE JUMPER
ACCESS
POINT
Access Point Interface
-
2400 – 2485 MHz
400 – 2170 MHz
OUT
To
50 OHM
TERMINATION
Antenna
Network
Figure 1 - 802.11 Access Point to Interconnection to WDS
The InnerMobile
®
System supports 4 types of antenna elements;
• Log Periodic Antenna
• Thin (PCB) Log Periodic Antenna
• Discone Antenna
• ½” Radiating cable
Antenna Type Gain (dBi)
LPA 7.1
PCB LPA 7.1
Discone 5.8
½” Radiating cable <0.0
- 6 -