User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
7-5
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-02
Chapter 7 2.4-GHz Radio Upgrade
Removing a 2.4-GHz Radio
Step 3 Remove the antenna wires from the blank spacer card.
Caution To avoid damaging the antenna wire assemblies, handle them by their connectors.
Step 4 Remove the blank spacer card from the mini-PCI connector.
For instructions on installing the radio card, go to the “Installing a 2.4-GHz Radio” section.
Removing a 2.4-GHz Radio
To remove a 2.4-GHz radio card from your access point, follow these steps:
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Step 1 Use your fingers to carefully remove the antenna wire connectors from the 2.4-GHz radio card.
Caution The antenna connectors can be damaged by using a pair of long-nose pliers during the removal
process.
Caution To avoid damaging the antenna wire assemblies, handle them by their connectors.