User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
7-7
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-02
Chapter 7 2.4-GHz Radio Upgrade
Installing a 2.4-GHz Radio
Installing a 2.4-GHz Radio
To install a new 2.4-GHz radio card into the access point, follow these steps:
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Step 1 Carefully remove the Cisco Aironet 2.4-GHz radio card from its anti-static bag.
Step 2 Grasp the radio card only on the edges, being careful not to touch components on the board or the gold
connector pins.
Step 3 Connect the black antenna wire connector to the radio card antenna connector marked by the black label
(see Figure 7-4).
Caution To avoid damaging the antenna wire assemblies, handle them by their connectors.
Figure 7-4 Antenna Connector Labels and Mini-PCI Connector
Step 4 Connect the white antenna wire connector to the radio card antenna connector marked by the white label
(see Figure 7-4).
MAIN AUX
74251
3
2
1
1 Antenna connector (black wire) 3 Mini-PCI connector
2 Antenna connector (white wire)