User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
8-5
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-02
Chapter 8 5-GHz Radio Module Upgrade
Installing a 5-GHz Radio Module
Installing a 5-GHz Radio Module
To install a new 5-GHz radio module into your access point, follow these steps:
Step 1 Before you can install a new 5-GHz radio module, you must remove the access cover or an existing
5-GHz radio module (refer to “Removing the 5-GHz Radio Access Cover” or “Removing a 5-GHz Radio
Module”).
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 3 Grasp the new 5-GHz radio module by it’s base (with the antenna pointing up) and insert the card into
the access point’s card-bus slot (see Figure 8-4).
Figure 8-4 Installing a 5-GHz Radio Module
Step 4
Push the 5-GHz radio module into the slot until you hear a slight click.
1 Access point 3 Access point card-bus slot
2 5-GHz radio module antenna 4 5-GHz radio card
74604
21
3 4