User's Manual
Table Of Contents
- Cisco Aironet 1200 Series Access Point Hardware Installation Guide
- Contents
- Preface
- Overview
- Installing the Access Point
- Configuring the Access Point for the First Time
- Using the Web-Browser Interface
- Using the Command-Line Interface
- Mounting Instructions
- 2.4-GHz Radio Upgrade
- 5-GHz Radio Module Upgrade
- Troubleshooting
- Translated Safety Warnings
- Declarations of Conformity and Regulatory Information
- Access Point Specifications
- Channels and Antenna Settings
- Console Cable Pinouts
- Glossary
- Index
First Draft - CISCO CONFIDENTIAL
8-7
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-02
Chapter 8 5-GHz Radio Module Upgrade
Installing a 5-GHz Radio Module
Note If your access point contains an internal 2.4-GHz radio or an 802.11G radio, there is also a radio
compliance label for that radio on the back of the unit.
The 5-GHz radio module installation is now complete and radio settings are at default values. To
configure the 5-GHz radio with your wireless network settings refer to the Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points.