User's Manual

SN10-12

REV 1.0 9/12/2017

InnoComm Mobile Technology Confidential

Setting up the command line interface

Figure 1

1) Stack the SN10-1x EVB on top of the KL25Z host boards to connect the SPI interface,

2) Connect the host board Open SDA to the PC with an USB cable,

3) KL25Z will pop up as a mass storage device. Open the folder and copy spi_sigfox_demo.srec to the

folder. (ask innocomm for spi_sigfox_demo.srec),

4) Start a terminal emulator (e.g. tera term) from the PC,

5) Configure the terminal settings to 115200 baud, 8 data bit, 1 stop bit, no parity and no flow control,

6) Press the reset button on the host board. The host board will show the list of SIGFOX commands on

the terminal emulator,

7) Enter the command code and follow the prompt to send the SIGFOX commands.

Description of the command codes, the data frames and the ACK frames, and the SPI protocol are

available

SigFox Software driver user guide ,

http://cache.nxp.com/assets/documents/data/en/user-

guides/OL2385SWUG.pdf?fsrch=1&sr=9&pageNum=1