Operation Manual
37
© INNOLUX Corporaon │ X-Ray Products
4.2 Detector Connection
Yushan detector can be connected to system either by wireless or by wire
cable.Yushan FPD use Dynamic Host Configuration Protocol (DHCP) to
assign IP address automatically.
4.2.1 Wire connection
The default address of Yushan is 192.168.11.100. User need to set the
computer to the same domain as Yushan. First, open the IPV4 of computer's
local network management interface, and change the IP address to
192.168.11.1 and subnet mask to 255.255.255.0.
After connection established, open Cmd.exe and enter ‘ping 192.168.11.100’
then press enter to check the network. If success, there is a reply from FPD as
below.