Installation Instructions

①

②

Reference before install the detector：

1. The detection range needs to take into account the area where illegal intrusion is most likely to occur;

2. Avoid placing the detector at the outlet of cold or hot air;

3. Avoid installing in direct sunlight or locations with strong electromagnetic interference;

4. Avoid large airflow in the detection area;

5. Avoid blind spots in the protection area (the detection range is shown in Figure 3).

The zigbee infrared intrusion detector is an indoor passive infrared intrusion detector, by detecting the infrared to

identify the invaders, and send the alarm signal to the Zigbee gateway through the alarm signal by the zigbee

communication protocol,carry out the on-site alarm at the same time, so as to prevent illegal intrusion, protect the person-

nel and property safety of banks, hospitals, factories, schools and houses, product appearance as showed in Figure 1.

• Ceiling/ wall mounting / horizontal placement magnetic suction installation,

small and beautiful One key-to-code configuration, reset and test features .

• Zigbee 2.4GHz wireless two-way communication .

• Dynamic threshold technique, enhance resistance-interference .

• Battery under pressure alarm .

• Positive and negative electrode Battery interface is fool-proofing.

Product Model：ED678 Series

Product No：PB0678BZ00/01/02/03/XX

Product Size：φ44mm*45mm

Working Voltage：DC 3V

Working Current：Standby Current≤18μA；Alarm Current≤25mA

Communication Method：Zigbee 2.4GHz

Transmission distance：≤130m (open visual distance)

Sensor element：Dual-element pyroelectric infrared sensor

Detection Distance：8m

Detection Angle：90°

Installation Height：2.4～3.6m

Alarm Output：Push the Zigbee gateway

Installation Method：Ceiling/ wall mounting / horizontal placement

Battery type：Button battery CR2450*2

working temperature：-10℃～55℃

Working humidity：≤95%(No condensation)

1.Select the area of monitoring human movement;

2.Open the rear cover counterclockwise in the direction showed in the drawing, pull out the insulation gear plate and

the product can be energized (as showed in Figure 2)

Features

Technical parameters

Installation Instructions

Usage Instruction

Indoor use passive infrared intrusion detector

figure 1

figure 2

PAGE 1
Indoor use passive infrared intrusion detector The zigbee infrared intrusion detector is an indoor passive infrared intrusion detector, by detecting the infrared to identify the invaders, and send the alarm signal to the Zigbee gateway through the alarm signal by the zigbee communication protocol,carry out the on-site alarm at the same time, so as to prevent illegal intrusion, protect the personnel and property safety of banks, hospitals, factories, schools and houses, product appearance as showed in Figure
PAGE 2
4 3 figure 3 2 1 110° 0 The shaded area is the effective distance for horizontal crossing. 1 2 10° 2.2m 3 4 0 1 2 3 4 5 6 7 8 9 10(m) 0 1 2 3 4 5 6 7 8 9 10(m) Operation and adjustment 1. Initialization state: After the battery is installed and powered on, the blue indicator light is always on, and the product enters the initialization state; if the Zigbee module is successfully initialized, the blue indicator light is off, and the product enters the normal working state. 2.
PAGE 3
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.