Installation Instructions

0
0
1
2
3
4
1
2
3
4
1 2 3 4 5 6 7 8 9
10(m)
The shaded area is the effective distance
for horizontal crossing.
110°
0
2.2m
10°
1 2 3 4 5 6 7 8 9
10(m)
Pair Key
1. Initialization state:
After the battery is installed and powered on, the blue indicator light is always on, and the product enters the
initialization state; if the Zigbee module is successfully initialized, the blue indicator light is off, and the product
enters the normal working state.
2. Pair the Zigbee gateway:
Open the APP, select the Zigbee gateway, click to add a sub-device, and then press and hold the device pairing
key for 5 seconds (as shown in Figure 4), the blue LED indicator flashes continuously, the device is reset, and the
network access request is automatically sent to the Zigbee gateway. After confirmation of the Zigbee gateway, you
can complete the network access, and the APP will prompt the device added successfully.
The longest configuration time is 2 minutes. If overtime, it will automatically exit the pairing mode.
3. Detection:
After the self-inspection is completed, it will directly enter the working mode, the tester will pass through the
detection area, the red LED indicator will be on for 1 second, and the detector will send an intrusion alarm signal
to the Zigbee gateway. After each alarm signal is sent, the product will enter the sleep state for one minute. , and
then enter the working mode.
4. Low-voltage alarm:
When the battery voltage is lower than the set value, the detector will send an low-voltage alarm signal to the
Zigbee gateway to remind the battery to be replaced in time.
1. The detection distance of the passive infrared detector will be affected by the outside temperature.
2. Anti-theft products can increase the safety factor, but cannot guarantee 100% safety. Users need to improve their
safety awareness to avoid losses.
3. The induction effect of this product is affected by factors such as ambient temperature, clothing, walking speed
and direction. When the ambient temperature is 15°C or lower, the sensing distance is normal or far, but in
summer or the ambient temperature is 30°C or higher , the sensing distance will be shortened.
4. This series of products are not waterproof and cannot be directly exposed to unprotected open air during use.
Notice
Operation and adjustment
figure 3