User's Manual

Innovation in Radar Technology
CONFIDENTIAL AND PROPRIETARY
The information contained in this document shall remain the sole and exclusive property of InnoSenT GmbH and shall not be
disclosed by the recipient to third parties without prior consent of InnoSenT in writing.
Page 4 USER MANUAL IPS-355 Version 1.0
PIN # DESCRIPTION IN / OUT COMMENT
1 d.n.c do not connect
2 enable input
active low, the enable pin is used to switch off the power supply of the OSC
enable on: 0 - 0.8V
enable off: 2.8 - 3.3V
3 V
cc
input supply voltage, 5V +/- 15%
4 GND input analog ground
5 IF1 output signal I(nphase)
6 IF2 output signal Q(uadrature)
7 d.n.c do not connect
8 d.n.c do not connect
9 d.n.c. do not connect
10 d.n.c do not connect
INTERFACE
The sensor provides a 2.54mm grid, single row pin header (square pin 0.635mm).