Manual

Installation Instructions for Innotech IG04 BACnet Gateway and Vaisala Transmitter / Sensor
Page 21 © Mass Electronics Pty Ltd 2011Edition 5.0 dated 11/11/2013
Services Tab
Under the Service tab you can configure or modify the following settings:
• Maintenance Mode – used for service by Innotech personnel.
• Server IP Address – only used when Maintenance Mode is set to Server or Client.
• Server Port – only used when Maintenance Mode is set to Server or Client.
• Reboot Gateway Now – Reboot the IG04 BACnet Gateway
The Maintenance mode is a service tool for Innotech personnel only. It MUST be set to Normal in order to view the data
from the Vaisala device, unless instructed otherwise, as illustrated in Figure 19 below.
NOTE
Figure 19: Configure IG04 settings in FusionLIVE – Service Tab